Skip to main content
COSTAR

Journal

Crawl Space vs Full Basement for a New Vancouver Home

By Costar Construction

Frequently asked questions

What does the BC Building Code require for a crawl space?

The BC Building Code requires a crawl space to have a minimum clearance of 600 millimetres between the ground and the underside of the floor joists or beams, to allow access for inspection and maintenance. The ground in the crawl space must be covered with a vapour barrier. The crawl space must be vented or conditioned to control moisture. The access hatch must be large enough for a person to enter.

What is the minimum height for a full basement in BC?

The BC Building Code requires a minimum floor-to-ceiling height of 1.95 metres in a basement used for recreational or habitable purposes. For a basement used as a secondary suite or a dwelling unit, the minimum height rules for habitable rooms apply. Ask your designer what height is required for the basement use you are planning, because the minimum varies by use.

Does a finished basement count toward floor area ratio in Vancouver?

In Vancouver, floor area ratio (FAR) rules are set by the City's zoning by-law for each zone. Basement floor area may or may not be counted, depending on how much of the basement is above grade and the specific rules of the zone. A basement that is fully below grade is often excluded from FAR calculations. Ask the City of Vancouver or your designer what applies to your lot and zone.

Is radon more of a concern in a basement than in a crawl space?

Radon enters a home through the floor and foundation, so the ground floor level and the basement are the most affected areas. A finished basement suite where people spend more than four hours a day is in the normal occupancy area under Health Canada's radon guideline, and the guideline of 200 Bq/m3 applies. A crawl space itself is not a normal occupancy area, but the floor above it can still have elevated radon if the crawl space is not properly sealed and ventilated. Health Canada recommends a radon passive stack in every new home, whichever foundation type is used.

What are the insulation requirements for a basement floor slab in BC?

The BC Building Code requires insulation under a basement floor slab in contact with the ground. The required value depends on the building's energy performance target under the BC Energy Step Code. At Step 1, below-slab insulation is required at a minimum RSI value. At higher steps, more insulation is required. The energy advisor on your project specifies the value needed to meet the target.

Sources

Start the conversation

Create your dream home. Tell us about your project today.